Imc-networks Wireless Outdoor Bridge XI-1500-IH Instrukcja Użytkownika Pobierz pdf (Strona 11)

TTestMacAddress-fill MacAddress of remote AP.

Transmit Pkt Num-display the number of frame be sended.

RcvPkNumLabel-display the number of frame be received.

Recv/Trans Rate-display the successful rate of transmitting.

Time Elapsed-show the time cost of sending data.

Local Signal Level－show local signal level.

Remote Signal Level－show remote signal level.

Note: View the intensity of signal, and adjust the positions and angles of the antenna

according to the intensity of signal. Adjust the antenna from side to side from head

to foot, observe the number value of signal level at the same time , when the number

value is 100%, the antenna is in the best positions and angles promptly.

Start－click it will begin test link：

Stop－click it to stop test link.

Close－click to stop test link.

Channel－test the channel quality.

Note: channel quality test must be perform after TX/RX data in gear, click “stop”

and the “channel” will be enable, click it to enter test window, be sure the MAC

Address of the remote Wireless Outdoor Bridge is right.

Start－click it start channel quality test.

Stop－click stop channel quality test.

Cancel－cancel test.

Set Channel－set the channel to the best one, remember click “Apply”.

Note: Two Wireless Outdoor Bridge’s channel will be reset after apply set channel.

1 2 ... 6 7 8 9 10 11 12 13

Brak uwag

Imc-networks Wireless Outdoor Bridge XI-1500-IH Instrukcja Użytkownika Strona 11